Sign In to join the community | Help
Tools & Hardware

how to change blade in power glide jig saw

how to change blade in power glide jig saw

Not what you were looking for ? Try posting a question
Posted 2013-05-05T14:27:32+0000  by 326sepasek 326sepasek
 

Hi 326Sepasek, welcome to the community, good question about this jig saw.

 

In the manual on page 8, it shows that you must slide the clear blade guard to get to the retainer screws.

 

Next you take the hex key that is supplied with the jigsaw. Loosen both blade screws; do not remove all the way.

 

Insert a new blade into the blade slot and make sure it is fully seated against the top of the blade clip. Ensure the teeth are facing forward. Alternate tightening each retaining screw. Adjust the blade ball support, and then slide the blade guard back into place until it locks into place on the base. Here is a manual for the jig saw.

 

http://www.ezreplacement.com/downloads/dl/file/id/211/60109820_powerglide_variable_speed_jig_saw.pdf

 

This will get easier after replacing blades a few times. Again we are glad you joined the community.

Posted 2013-05-09T20:17:40+0000  by Ken_HD_OC
 
Not what you were looking for ? Try posting a question

Topic
Categories+