09-22-2011 03:08 PM
I want to install a corrugated metal roof on my existing patio. Are there any tips for nailing/screwing the panels on? I know I need the closure strips to keep the panels in shape. What kind of screws or nails should I use, and do they get fastened in the valleys or on the peaks of the corrugation?
09-22-2011 07:22 PM
Hi bill52morris, Hi and welcome to the community. Great project you have going.
Your question for tips on screwing the corrugated roofing panels on an existing patio cover is something you definitely can do yourself.
First you need to pre-drill the holes on the corrugated roofing panels.
Start by placing one panel at a time on the rafters and cross brace. Place the closure strip on top of the corrugated metal and drill through the closure hole in the valley. This uses your closure strip like a template and ensures the panels and closure strips are aligned.
You can screw/nail the closure strip to the cross braces using exterior rated fasteners.
You will want to use screws that have a neoprene washer when attaching the panels.
Finally, attach the panels using the pre-drilled holes to the rafters. And make sure you overlap each panel at least one corrugation over the other.
Hope this answers some of your questions. Please post some pictures of your project.
I’m a Home Depot Store Associate, trained and authorized to help people on the Internet
09-23-2011 03:52 PM
Just to be clear.......when I am pre-drilling the holes through the closure strips into the corrugated roofing in the valleys, is the corrugated roofing panel upside down? In other words, when the roofing is right-side up, and I'm ready to fasten it, am I screwing into the valley, or the peak of the corrugation. Thanks.
09-23-2011 05:59 PM
Foodieken is out of the office today so I thought I would help you out with your question.
The correct placement for the screws are in the valleys. I found a diagram on our vendor’s website so I thought I would add that since I believe a picture is worth a thousand words.
Depending on your location. If there is a lot of rain than some people have been known to put the screws just above the valley so that the water is not running directly over them. This technique takes a little bit of practice though. I would suggest staying with the manufactures recommended placement.
I would also agree with Foodirken that it's a must to use the screws with the neoprene washers.
Please let me know if you have any other questions. I would love to help.
"You can't do it if you don't try". Believe in yourself!! ______________________________________________________________________
I am a Home Depot Store Associate, trained and authorized to help people on the Internet.
09-26-2011 11:00 AM - edited 10-10-2011 12:32 PM
Bill i just wanted to add something, from my previous experience, to the great advice given above.
Depending on the panel profile and slope of the roof some manufactures require sealant (caulk) to be used in between each lap joint. See attached PDF;
Purpose of the sealant is to prevent side driven rain and ice buildup in between lap joints.
Also couple installation tips;
Use recommended butyl base sealant.
These sealants are made from high quality butyl rubber and stay permanently flexible.
Don’t over apply sealant.
Apply only a 1/4 bead on top of the panel rib, anything more than that will force sealant out of the lap on to the adjacent panel and you’ll have a mess on your hands.
And finally use chalk line for the fastener placement, Screws are esthetic feature with exposed panel installation.
“Let the future tell the truth, and evaluate each one according to his work and accomplishments. The present is theirs; the future, for which I have really worked, is mine.”