02-19-2011 09:37 AM
02-19-2011 02:19 PM
When my parents got me "involved" with installing their bathroom fan in their house a while back, I got the jist of the in's and out's of bath fans. I did some research at my store before putting it in, and here are some options that may work for you.
Option 1: Saving the fan w/ replacing just the motor
Hopefully you will have access to the attic so you can see the release tab as it maybe better accessed from that angle, depending on your model. This option of coming in that way makes it easier for you to see any additional screws or tabs. Plus, you can clean out the area of dust that has collected over time while you are up there. If you cannot get into the attic, you can attempt to check the manufacturer's model # and I can get you an online link to the manual. When you do get it out, I recommend getting an upgrade kit that we sell in stock that works for most models:
With option 1, its going to be a bit more time consuming project than a money one, since finding a replacement motor may not fit into the existing box. Be sure to check with a licensed electrician or HVAC repairman for any questions we didn't address here or for specific reconfiguring.
Option 2: Replace the entire bathroom fan
Sometimes its just easier and cheaper to replace it outright if option 1 doesn't work out. Plus, you can save time knowing you haven't altered the housing by trying to take the motor itself out with possible damage. Usually this is the way most of my customers I have spoken to over the years do, as sometimes if you can find a replacement part for your fan, it may not be the exact fit. Come down to your local store and our associates in the Kitchens/Bath department can get you the right replacement fan and/or parts. Also, check out the link I provided that has a lot of online choices as well here.
The only drawback to this is if you have bought a smaller or larger unit, youd need to reconfigure the duct and drywall in the ceiling so that the unit can fit snug and safely. However, the end result means you can have a perfectly working bath fan for years to come.
Hope this helps you out and any further assistance let us know
I am a 12 year Home Depot Store Associate, trained and authorized to help people on the Internet.
11-07-2012 02:24 PM
I have a 25 year old house with Fasco bathroom vent fans (Model A692) that are a combination fan, light, and heater (ceiling mount). I took out the old motor for the vent fan as even though it runs there is no air movement. The motor also makes some noise. I purchased a replacement Nutone motor and fan of the same size at Home Depot. I noticed that the new fan has large openings between each blade, such that air will flow through. The old one, although identical in size, is solid instead of having those openings. The fan is a 4.5" plastic unit that slides on the motor shaft. Will that affect the air flow (the vent fan housing is designed with a side exhaust). I also need to check or possibly replace the duct as that could also be why there is no air flow.
12-10-2012 12:05 PM
For anyone still needing help with this......
Had the same issue - my motor housing did not have a screw or any clips I could see.
Used this video as a guide.
After I REALLY dusted out the motor housing I was finally able to see the clips - 1 large one in the center of one side and 2 smaller ones on the opposite side.
New motor unit cost $15 and took about 10 mins to install (after finding the clips, of course ).
11-04-2013 05:11 PM
02-04-2014 11:19 AM
I was looking to change my bath fan because it looks really old and it does make a lot of sound. The model is a Marley A647a fan with a 3900-2059-000 motor assy. I was looking at the web and they don't make it anymore. The specs are:
I was wondering wich fan can replace this one or if any of the upgrade kits can help me. I would appreciate any help on this issue.